Music stands can be found in several varieties and styles, and can be created from a number of materials. But with few exceptions, all of them share the identical basic parts. From lower to upper these contain the “base”, the “shaft”, and the “tray”.
The base of a sheet music stand will most often have three legs and become of either a tri-pod or standard, fixed-base design. A tri-pod base attach’s the tops of the legs for the shaft part way up from your floor, with three bottom contact points on the ground. These types of legs are more often than not foldable or collapsible. Nearly all folding and portable written music stands are made this way. A stand having a standard base will even often have three contact points on the ground, but the opposite end of the legs will most likely be steel-welded to the base of the shaft. This may provide the stand more stability, and can sacrifice the capacity of the are in position to easily fold down into a smaller space for further convenient carrying. Most stands present in schools are of this type.
The center area of the music stand, which connects the base with all the tray, will be the shaft. If the stand is height- adjustable, then most likely the shaft will have two tubes, one in the other. These tubes will telescope and then lock on the desired height. In case a stand has a standard base, then it is highly likely that the shaft is going to be of a “one piece” design. That is, the outer tube will certainly be a single piece and will not collapse to the shorter compared to the minimum playing height. In case a stand has a tri-pod base, then it could have a one, two, or three-piece shaft (or more). Multiple-piece shafts will either telescope as a result of a very small size for easy transport, or the pieces will separate and therefore occupy a lot less room side by side. Naturally, the only piece shaft is regarded as the strongest, however, folding and portable music stand shafts have grown to be stronger in recent years.
The a part of Music Stand which actually supports the music is often referred to as tray or perhaps the “desk”. The tray consists mainly of two parts. The vertical backing is known as the “bookplate”, and is usually either a single, solid piece, or possibly is made of several interconnecting bars that have spaces between the two (as with folding stands). The diieaz support (which ensures you keep the written music from falling towards the floor) is referred to as the “shelf” or perhaps the “lip”. The average depth of any shelf is approximately two inches, but this can vary depending on the intended use of the stand. When a musician intends to read music from books, as an example, then the stand using a deeper shelf could be needed. The shelf usually comes as either a single, attached piece, or perhaps is by two parts which fold together on the middle. The whole tray (bookplate plus shelf) may or may not be adjustable for tilt angle, and varies in size and strength.
Written Music Stand Differences
These are the basic basic elements of the vast majority of music stands you will come across. Most of the exceptions are usually in favor of artistic design are available from stands which can be very beautiful, but sometimes not easily portable. A few examples include music stands with solid (legless) bases, duel-shafted stands, and jazz or “big band” style cardboard stands. And given there are a myriad of sheet music stand designs, having a grasp from the basic workings of probably the most important items a musician will use is useful for 2 reasons. Growing your current musical knowledge is definitely important; and becoming knowledgeable about these specific terms can make you better in a position to compare different stands for your own personel musical needs.